【J. Am. Chem. Soc. 2009, 131,3042–3048】

近期，Genentech公司的Yang和Dalton發現了一種替代性甲基化試劑----氯甲基三異丙氧基硅烷（CAS: 18162-82-8，已商業化）可以完美解決吡唑N-甲基化的選擇性問題，這種大位阻的替代甲基化試劑可以對吡唑雜環進行高選擇性的N-甲基化反應。選擇性烷基化后在TBAF和水存在下，能夠容易地進行脫硅基反應，生成N-甲基吡唑。對多種吡唑底物，獲得了92:8到>99:1的N1/N2異構體比率，并且產率良好?！?em>J. Org. Chem. 2024, 89, 4221?4224. DOI: 10.1021/acs.joc.3c02841】

替代甲基化試劑的篩選，大位阻的三異丙酯選擇性最好。

烷基化后，一鍋法直接加入TBAF進行脫硅基化反應得到最終的N-甲基化產物。

反應操作：

Alkylation procedure: All reactions were conducted in a 20 mL vial with a sure-link cap with a magnetic stir bar. To a 20 mL screw cap vial was added: 3-(4-fluorophenyl)-1H-pyrazole (1.0 equiv., 1.54 mmol, 0.250 g), dimethyl sulfoxide (2.5 mL, 10 mL/g, 35 mmol) and potassium bis(trimethylsilyl)amide as a solution (0.91 mol/L) in THF (1.5 equiv., 2.31 mmol, 0.91 mol/L). The vial was placed in an aluminum block at 60 ℃ and stirred for 30 min. To this solution was added: (chloromethyl)triisopropoxysilane (1.5 equiv., 2.31 mmol, 96 mass%). 

Protodesilylation procedure: After 16 h, tetrabutylammonium fluoride as a solution (1 mol/L) in THF (2.0 equiv., 3.08 mmol, 1 mol/L) and water (10 mL/g, 139 mmol) were added to the reaction mixture at 60 ℃. Samples were analyzed for conversion and assay yield by reverse phase HPLC (6 uL reaction sample in 500 uL diluent: 8:2 ACN/Water). Assay yield was calculated with reference to biphenyl internal standard (mass/mass) with an absorbance correction factor applied where required. 

Workup: For a 250 mg scale (substrate) reaction with 2.5 mL DMSO, 0.5 mL of 10% (g/g) NaHCO3 and 0.3 mL of brine was added to the reaction mixture with 5.0 mL of i-PrOAc. Mixture was shaken and the aqueous layer was separated. The aqueous layer is then back extracted with i-PrOAc (3x). In the last wash, 0.2 mL 14% (g/g) Na2SO4 is added to the mixture to ensure drying of the organic layer. The combined organic layers were then dried over MgSO4, filtered and concentrated via rotary evaporation.

Chromatography: Reaction crude was dissolved in a minimal amount of DCM and directly loaded onto a prepacked silica column. Purification was completed by flash chromatography (Combiflash) with gradient elution from 0 to 20% i-PrOAc / heptanes over 40 mins. HPLC Analysis Method: Column: XBridge BEH C18, 3x100mm, 2.5 um. Rate: 0.7mL/min, 30 oC, 220 nm UV detection. Mobile Phase A: 0.05% TFA in Water, Mobile Phase B: 0.05% TFA in ACN. Elution: 0-0.5’ 2%B; 4’ 35%B; 7-10’ 90%B, 10.1-12’ 2% B.

參考文獻：

1、J. Am. Chem. Soc. 2009, 131,3042–3048